How can I run RTEMS BSP tests for RISCV using a simulator?
I followed the RTEMS quick start guide for sparc/erc32.
In attempting to perform the BSP tests, I ran into the same problems highlighted in a separate thread, but followed the instructions in that response and was able to execute tests with the Software Instruction Simulator (SIS), as follows:
rtems-test --rtems-bsp=erc32-sis --rtems-tools=$HOME/quick-start/rtems/5 .
The response stated that the SIS also supports RISCV simulation.
I went through the installation instructions again for riscv/rv32i, but was not able to execute bsp tests with SIS.
rtems-test --rtems-bsp=rv32i-sis --rtems-tools=$HOME/quick-start/rtems/5 .
fails with the following:
error: cannot find bsp configuration file: rv32i-sis.ini
Looking in the directory with erc32-sis.ini, I only find riscv .ini files associated with spike.
Run the following command in the rtems source directory, you will get the supported list of BSPs: