I am trying to simulate a communication protocol where I am following a pattern, so I constantly loop though looking for the same set of characters to reply information. I'm using an RS-232 adapter and the protocol I am simulating is asynchronous and half-duplex where the rx/tx lines are tied together by design and that causes a sort of echo when reading after writing.
That said, I need to be able to clear the input buffer after every write I send out in order to avoid reading what I just wrote. So whenever I use reset_input_buffer() it does not clear the last message I sent out. I have tried to fix this using a couple of methods, such as: using reset_output_buffer() together with reset_input_buffer(), using reset_input_buffer() twice, and using flush(). None of these methods make any difference, the only other method that works to clear the buffer is closing and immediately opening the port but this causes a delay that messes with the timing as it is critical at certain times.
I'm open to any suggestions, please help!