I am sorry if its basics, but I did not find the appealing answer for it over the Internet. Why only MAC is used to transfer the packet to a device ? MAC address is only obtained by ARP for a specific IP address. So, why not just let the routers maintain IP addresses of the neighbouring routers and route packets using IP addresses of routers instead of MAC addresses ?
Why not redesign the architecture, to only use IP address for routing as well as moving the packet in the data link layer too ?
Why do we need MAC addresses?" Why can't network devices such as the routers just send the packet to the next router using the router's IP address?
Note : I know that MAC address is used to identify the system in a network. But you see the source never knew the MAC address of receiver. All it knew was its IP address and MAC address of next hop.
I'm reading Data Comm and Networking by Forouzan ( Ed 5) and it says that even routers have an IP address. So why use the mac address at all. The router can store the IP address of the source and route it to the next router .
EDIT : The question that I was getting as suggestion to this one does not answer my query. There are multiple counter points and proof that I have presented here which could have been done which is not answered by the one which is suggested. So please read my question before making any assumptions.
What do you think makes more sense: Having one protocol like Ethernet handle all the layer 2 details so that its layer 3 payload doesn't have to care, or force IP, ARP, WoL, IPX, MPLS, SLPP, and dozens more implement it on their own? The whole purpose of OSI layers is that upper layers need not know all the lower layer's details and lower layers need need not support the upper layer's features.
MAC addresses are used for the layer 2 protocol which encapsulates a layer 3 protocol. If all the necessary features were embedded into IP, then you'd be leaving other protocols to re-implement layer 2 routing on their own. This would be wildly inefficient.